You are currently reviewing an older revision of this page.
Snap modes are disabled using SmartLine.Some snap modes (Tangent, Parallel, Perpendicular) are disabled (grayedout) when using SmartLine.Snap modes are disabled when AccuDraw is disabled.Snap modes are disabled when in a 3D file.Product: MicroStation V8iVersion: 08.11.05.17Area: General, PROBLEMSOLVING
Enable AccuDraw.Starting in MicroStation V8i, the constraint snaps are not available ina 3D file if AccuDraw is not enabled.AccuDraw is used to assist these constraint snaps when using SmartLine.Place line still uses the old behavior.To be able to use these snap modes with SmartLine, enable AccuDraw(Toggle is located on Primary toolbox).Notes:Originally reported as a problem in TR# 226975