Model for Environmental pushover

You can create a SACS model file from the final step of the collapse analysis by inputting 'SF' in columns 38-39 on the CLPOPT line. Refer to Section 2.2.1.8 of the Collapse manual.

Regards,

Geoff

Many thanks Geoff.
But how to call-up this file for post impact analysis? Does SACS create a new sacinp file? Also does SACS create the deformed model at first joint failure...!? Please briefly suggest how it's done in practice...

Thanks.

SACS creates a new sacinp file with the deflected shape from the last load step analyzed in collapse. I don't know why one would want to run a static analysis after a collapse analysis is performed since you are essentially performing a static analysis which includes the nonlinearity of the members and the deflected shape already, but it is there in the event that one needs it.

Regards,

Geoff

Thanks Geoff.
I was wanting to do it for collapse analysis involving ship impact. To apply post impact environmental loads I was wanting a deflected structural model.
Regards

continuing on ...: )

Below picture is from SACS collapse vue manual ...For a collapse analysis how to get deformed model view with this quality?!

Many thanks.

Hello, want to ask, if this issue is solved, how do we apply post-impact environmental loads to the structure? cause when I apply the envi load to the model keep getting these errors

*** ERROR - LABEL WAVE NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** SLV MODULE TERMINATED DUE TO ERRORS DETECTED IN THE PRE MODULE ***

 

Hello, want to ask, if this issue is solved, how do we apply post-impact environmental loads to the structure? cause when I apply the envi load to the model keep getting these errors

*** ERROR - LABEL WAVE NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** ERROR - LABEL CURR NOT RECOGNIZED AS PROPER

*** SLV MODULE TERMINATED DUE TO ERRORS DETECTED IN THE PRE MODULE ***