Based on fatigue results, I tried to get joint details by using EXTRACT input line but it doesn't work. Another person asked the same question previously without getting any answer.
Joint extraction only is applicable to tubular connections. Unfortunately non-tubular connections are not yet supported.
Regards,
Geoff
Answer Verified By: van - Uyen NGUYEN
Thank you for your quick answer.
I'm performing spectral fatigue analysis with version 5.7 V8i
I tried all the above commands but it still didn't work for I-shape. In fact, EXTRACT works very well for tubular connection.
When I used EXTRACT for I-shape, I got the following message for interactive fatigue:
Regards
Uyen
What type of fatigue analysis are you performing? What version of SACS are you using?
The easiest way to extract all joints for interactive fatigue using this line in your fatigue input file.
EXTRACT HEAD AL
You can also extract joints above a certain damage level using:
EXTRACT HEAD AE 0.5
Or extract specified joints:
EXTRACT HEAD EXTRACT 403 407