Dear Sir/Madam,
Currently, I'm working on creating a hexagonal Single Point Mooring model in MOSES EDITOR. I need to form the compartment model inside the SPM.
Since the SPM has a hexagonal form, thus the compartment has to be a Triangular Prismatic as you can see in the attached figure below. I found it difficult to create the triangularly prismatic form if I use plane command.
Is there any alternative method that can be used for this work?
Thank you in advance.
Here's the example of my build up command:
&dimen -save -dimen Meters M-Tons&describe body COBAPRISMA&describe Body Tank001pgen -PERM -1 -PORT -LOC 0.00 0.00 0.00 -diftype NONE plane 0 -cart 0.00 0.00 3.474 0.00 3.474 5.641 plane 6.0040 -cart 0.00 0.00 0.000 0.00 0.000 5.641end pgen&describe Body Tank002 pgen -Perm -1 -LOC 0.00 -3.474 0.00 -diftype NONE PLANE 0 -cart 0.00 0.00 0.000 0.00 0.000 5.641 plane 6.004 -cart 0.00 0.00 3.474 0.00 3.474 5.641end_pgen