Hi everybody!
I am reading and follow the manual call Learning maxsurf manual.
In chapter 5: Designing in Maxsurf. There is a section called starting a design_ Video.
You can click web or disk. When I click web appear videos but not that video. This is the web I am sent:
www.bentley.com/.../maxsurf
When I click a disk, appear the image that I attached.
I would like to find the disk of the learning manual.
Can you help me?
Thanks in advanced.
Regards,
MJ
I found the old training material you were referring to and you can download it here:
Learning MAXSURF - Self-paced training material from 2011 - MAXSURF | MOSES | SACS Files - MAXSURF | MOSES | SACS - Bentley Communities
communities.bentley.com/.../learning-maxsurf-manualLearning MAXSURF - Self-paced training material from 2011
This is somewhat dated self-paced training material that we created in 2011. However the underlying principles of how the software works are essentially the same. In the newer versions of MAXSURF you will find an updated user interface and many new commands, so there are possibly alternative ways of doing things these days.
This training material will give you a good introduction to modelling with NURB surfaces in MAXSURF Modeler. It contains a pdf document which takes you through the various steps and also some short video clips which demonstrate the various topics described in the text.
Don't forget that there are also many instructional videos on our You-Tube channel: Bentley Offshore Analysis - YouTubewww.youtube.com/.../playlists
Thank you very much!!!
I would like to know where I can find updated training material in order to find the alternative ways of doing things in the newer versions of MAXSRUF.
Thanks again.
María
the you-tube channel and the manual are the only other resources we have available
Thank you.
Sorry for asking so much.
with manual, you are referring to the old manual or some updated manual?
I am no able to find the updated manual.
Could you say to me where I can find the updated manual? ( in the case there is one)
you should use the manual thats installed with the software :-) Then the manual will correspond to the software you are using. It wont necessarily make sense to use the manual for version 23 if you are using version 20 software. You can download the latest version from Software Downloads (bentley.com) (if you have SELECT subscription)
Thank you for the information.
I have downloaded version 23.
Thank you for everything again. I found interesting all the material especially the old one with videos.
Thank you again.
Have a good weekend,