Hi Bentley
there is an error when i'm trying to perform my own Launch Analysis. where i'm using my own SACS converted jacket .dat file. here was the log file of the errors. is there anything that maybe considered to be missing on my command line.
thanks, regards.
*** ERROR: No Element Found Between Nodes *J1412 *J1512 ========================================================== *** ERROR: No Element Found Between Nodes *J1411 *J2511 ========================================================== *** ERROR: &LLEG1 Has Been Specified, But Not Defined ======================================================== *** ERROR: &LLEG2 Has Been Specified, But Not Defined ========================================================
I did a scan with my eyes. I did not see *J1411, *J2511. Can you highlight them?
hi Georgina, thank for the answer.
I've checked my .dat of SACS converted model, and all the beam/member were already defined. this errors only show up when i do "assembly lleg" of complete launch leg. here's some screenshot of my moses file. is there anthing that i should re-check?
regards
Hi Arif,
You did not report if you make the obvious checks. Did you check if there is an element between nodes *J1412 and *J1512? Did you check if there is an element between *J1411 and *J2511?
I hope this helps.
Georgina Maldonado