Can beam nodes/IDs be selected in the Time History Location (THL) file?

Hi, we have a complex model containing pipework and its corresponding structural supporting frames, and would like to apply a ground acceleration time history to the frame support points where they connect into the building structure. However, when selecting these in Time History Location, AutoPIPE (Version 12.05.00.16) provides the following error message stating the beam nodes are "Invalid Point(s)". Pipework points and supports can be selected in the THL dialogue box. Is there any way to apply a Time History to beam nodes (or any neat workarounds suggested)?

Kind regards,


Tim

Parents
  • Greetings,

    Are you trying to do a Time history ground motion where the same THP is applied to all the supports connected to ground. Then you only need to perform the following:

    1. Define the THP (Time History Profile)

    2. On the Time history Dynamic Dialog created a new Load case, check the box for Ground motion and press the Define button to select the profiles (ex. Test) for the given direction (ex. X-dir) to be applied. 

    3. Run Analyze all. 

    4. Review results. 

    5. Done.

    However if trying to model a MSRS as a time history where one can define a particular spectrum for a specific set of supports attached to Pipes. Then create a THL (Time history location) file by using the dialog feature or manually as indicated in AutoPIPE help.

    There does seem to be an issue with adding a beam node point supported by anchor in the THL dialog (see image above and below). I have asked the development team to investigate the issue (713085). I will post more information on this thread after the development team's review and response.

       

    Regards,
    Mike Dattilio
    Design Analysis Engineering Group
    Senior Analyst Bentley Systems Inc
    =============================================================================

Reply
  • Greetings,

    Are you trying to do a Time history ground motion where the same THP is applied to all the supports connected to ground. Then you only need to perform the following:

    1. Define the THP (Time History Profile)

    2. On the Time history Dynamic Dialog created a new Load case, check the box for Ground motion and press the Define button to select the profiles (ex. Test) for the given direction (ex. X-dir) to be applied. 

    3. Run Analyze all. 

    4. Review results. 

    5. Done.

    However if trying to model a MSRS as a time history where one can define a particular spectrum for a specific set of supports attached to Pipes. Then create a THL (Time history location) file by using the dialog feature or manually as indicated in AutoPIPE help.

    There does seem to be an issue with adding a beam node point supported by anchor in the THL dialog (see image above and below). I have asked the development team to investigate the issue (713085). I will post more information on this thread after the development team's review and response.

       

    Regards,
    Mike Dattilio
    Design Analysis Engineering Group
    Senior Analyst Bentley Systems Inc
    =============================================================================

Children