Problem:

The following occurs when importing a model into AutoPIPE:

Forrtrl: severe (64) - Input conversion error, unit 95, file...

Solution:

The problem here is that may be using the wrong version of AutoPIPE to  open the CAESAR file.  Please see the following  limitations of AutoPIPE and CAESAR here.

Recommend using on of the following solutions:

Solution #1:

Convert CAESAR file format back to a format that can be read by the AutoPIPE version in use. Refer to above information for details.

Solution #2: Manually fix the file by opening the CAESAR CII file in Notepad and follow the instructions below.:

Older builds of CAESAR 5.3 have an issue with $CONTROL section - where location of a variable was incorrect. This is a known issue - that is also mentioned in release notes of CAESAR. Following is an example of the problem with the new variable that is in the middle of the CONTROL card instead of the end.

 Data generated by CAESAR II / Neutral file interface Ver 5.30,  9/10 #$ CONTROL

You can fix it by either changing the #$CONTROL card by moving this new variable to last row or
   Data generated by CAESAR II / Neutral file interface Ver 5.30,  9/10 #$ CONTROL

Solution #3: Install latest SP2 of CAESAR 5.3 before exporting CII file.

Please note that any CAESAR models exported from CAESAR 5.3 will have this problem unless Service Pack 2 or higher of CAESAR 5.3 is applied.

See Also

Visual Fortran run-time error messages

Bentley AutoPIPE