You are currently reviewing an older revision of this page.
Q1. How is Buoyancy added in AutoPIPE?
Answer: In AutoPIPE buoyancy weight is applied in GR case. It has both longitudinal and transverse components. When the pipe is vertical, difference in pressure cap forces is the same as buoyancy load and the transverse buoyancy is zero. When the pipe is horizontal, the cap forces from external hydrostatic load adds longitudinal stress and associated movements in addition to non zero transverse (vertical) buoyancy load.
Q2. Is Pipe insulation and Cladding accounted fro in bouyancy?
Answer: Form the online help:
Clad thickness: For wind loading, hydrotest, buoyancy and wave loading, the total diameter of pipe includes the cladding thickness.
Insulation thickness: The insulation thickness is also used to calculate the surface area of the pipe for wind loads and buoyancy effects.
Q3. How do I know if Buoyancy loads are being applied to the pipe?
Answer: must have 2 identical models, applying Load> Buoyancy in only one model, and then compare the results of all the vertical support loads under GR load case. The difference between the total vertical support values is the buoyancy load applied to the piping.
Remember All points with a vertical coordinate value less than the "Water surface elevation" value specified on the Load> Buoyancy dialog will be considered submerged (buoyancy load is applied). Pipe above this value will be considered above water and NO buoyancy will be applied.
Note: Confirm Segment tab on the input grid, "Apply Buoyancy" column for check boxes where Buoyancy load is to be applied:
Q4.
Bentley AutoPIPE
Bentley Technical Support KnowledgeBase
Bentley LEARN Server
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article tothe "Comments" area below. THANK YOU!