You are currently reviewing an older revision of this page.
Can AutoPIPE model pipe inside of pipe (i.e. Vacuum Pipigng or Jacketed Piping) :
Answer:
See the following WIKI here, #4 Jacketed Piping
Is AutoPIPE able to analyse a piping system under negative pressure?
The piping design codes always work in gauge not absolute pressure and so does Autopipe. The code compliance is for mechanical loads plus positive internal pressure i.e. Pipe code stress calculations do not consider negative pressures.
B31.1-2004 Section 104.1.3 refers to ASME BPVC code for such calculations. Pipes can carry very little external pressure compared to internal pressure due to collapse or buckling of pipe wall. Sometimes stiffening rings are added to increase resistance to external pressure. You can still use AutoPIPE for other type of loads.
B31.1: 104.1.3 Straight Pipe Under External Pressure. For determining wall thickness and stiffening requirements for straight pipe under external pressure, the procedures outlined in UG-28, UG-29, and UG-30 of Section VIII, Division 1 of the ASME Boiler and Pressure Vessel Code shall be followed.
B31.3-2006 refers to the same ASME code but with some other limitations under section 304.1.3.
Typically for vacuum systems - the external pressure loading on the piping system needs to be checked independently to a pressure vessel code (e.g for ASME section VIII div I). But for code compliance - the vacuum system will also have specified some positive internal design pressure (gauge) which would be used in the pipe stress calculations. Then a 2nd temperature case T2 defined with the vacuum pressure (-ve) entered and provided the pressure analysis is turned on under AutoPIPE's Analysis Sets, the P2 case will show displacements and loadings for this case for use in design on supports and equipment. But this case is ignored for stresses.
In conclusion, . Vacuum pipe wall thickness and stiffening stress requirement should be done separately following the applicable code. AutoPIPE cannot perform this analysis nor can it handle external pressure at this time some enhancements have been logged to included these features in a future version of the program. However, AutoPIPE can be used to check other loading conditions in a vacuum system such as pressure contraction, thermal, and occasional loads.
Bentley AutoPIPE
Bentley Technical Support KnowledgeBase
Bentley LEARN Server
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article tothe "Comments" area below. THANK YOU!