You are currently reviewing an older revision of this page.
The following is displayed when I am inserting a bend in my model:
---------------------------Error--------------------------- E732-2: Angle is 180 deg. at bend A11 ---------------------------OK ---------------------------
How to resolve the issue ?
Typically this message is displayed when the user actually enters a direction that is directly back in the same axis as the initial pipe run before the bend.
1. Insert New segment, start point : DX= 0.00, Dy=0.00, Dz=0.00
2. Insert pipe run, Dx = 5.00 ft
3. Insert Bend, Dx = 5.00 ft.
4. Insert pipe, Dx = -3 ft. press OK button and Error above appears.
Enter any other direction that constitutes a valid piping bend component.
Example: from Step #4 above, enter pipe run, DX= -3.00, Dy=5.00, Dz=0.00,
Bentley AutoPIPE
Bentley Technical Support KnowledgeBase
Bentley LEARN Server
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article tothe "Comments" area below. THANK YOU!