You are currently reviewing an older revision of this page.
The following is displayed when I am inserting a bend in my model:
---------------------------Error--------------------------- E732-2: Angle is 180 deg. at bend A11 ---------------------------OK ---------------------------
How to resolve the issue ?
Typically this message is displayed when the user actually enters a direction that is directly back in the same axis as the initial pipe run before the bend.
1. Insert New segment, start point : DX= 0.00, Dy=0.00, Dz=0.00
2. Insert pipe run, Dx = 5.00 ft
3. Insert Bend, Dx = 5.00 ft.
4. Insert pipe, Dx = -3 ft. press OK button and Error above appears.
Enter any other direction that constitutes a valid piping bend component.
Example: from Step #4 above, enter pipe run, DX= -3.00, Dy=5.00, Dz=0.00, thus providing a direction other thatn the axis of the original piping before the bend.
Bentley AutoPIPE