a. "Flange Analysis" sub-report in AutoPIPE
Comments, Questions, and Answers about AutoPIPE's Flange Analysis Sub Report
What does "Inside diameter of flange should be equal to inside pipe/nozzle diameter" mean in the Flange Analysis Output report?
Flange Analysis report does not contain any results, only page headings
When multiplying the Flange volume by the Flange density it does not equal the reported Flange Weight, why?
What is the difference between the "Operating Condition" and "Gasket seating condition" in AutoPIPE Flange analysis report?
"ANSI Flange Check" sub-report using Flange Analysis command
Calculate Bolt Tensile Stress
**NOTE: The gasket seating condition stresses are calculated using the full available bolt load, where Wg = [(Am + Ab)*Sa]/2.
Operating pressure appears to not be added to Equivalent pressure calculation
What defines this "thickness range"
See Also
Analysis Sub-reports FAQ
Bentley AutoPIPE