You are currently reviewing an older revision of this page.
How can I set the RESTRAINED pipe option for B31.8 2007 onshore / underground piping
Please see the following AutoPIPE help section:
Help > Contents> Contents Tab> Reference Information> Code Compliance Calculations> ASME B31.8-2007> Code Combinations
Here you will see 2 charts displayed, restrained and unrestrained. Note that the combination's category will determine which calculators are used, i.e. restrained or unrestrained equations. Under the charts are a number of notes that you should review for a better understanding of AutoPIPE's analysis.
The calculations for restrained piping is conservative and assumes a small amount of contribution from bending, even on straight piping. The more restrained the piping is with more supports or higher soil properties the less contributions from bending and the closer to code calculations for St = E x alpha x (delta T).
In AutoPIPE v8i 09.06.01.xx. a new tab has been added to the Input grids to allow better control over the calculations for a section of piping (ex. A01 - A02) and data displayed in the output report. Please see the new Pipe Restraint tab where the user selects 1 of 3 options for each section of piping (i.e. unrestrained, restrained, Show both rest / unres).
Bentley AutoPIPE
Bentley Technical Support KnowledgeBase
Bentley LEARN Server
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article tothe "Comments" area below. THANK YOU!