You are currently reviewing an older revision of this page.
Issue #1: Multiple loads are not being exported / imported into AutoPIPE Nozzle (ex. T1 - Tn), why?
As seen below there are multiple temperature loads being analyzed but on GR loads are being imported into AutoPIPE Nozzle, why?
Only those defined individual load cases that are printed from AutoPIPE Non-code combnation table can be exported to AutoPIPE Nozzle. Note, No combinations are imported into AutoPIPE Nozzle.
Example:
Of the following load cases and combinations (Gr, T1-T5, E1-E10, W1-W4, P1-P5, GrT1-GrT5) only those individual AutoPIPE load cases (Gr, T1, T2,E1, E2, W1, P4, P5) where the PRINT check box Enabled on the Non-Code combination Tab will be imported into AutoPIPE Nozzle, as shown below:
AutoPIPE Non-Code Combination Tab:
AutoPIPE Nozzle:
Note:
1. When importing a loads into AutoPIPE, be sure to press the Update button First, then select your Nozzle / reference point from the Drop Down listing and then press OK button.
2. AutoPIPE Nozzle Load Cases names do not match AutoPIPE's load case names (ex. AutoPIPE Load case E5 becomes, AutoPIPE Nozzle E1). All the load case names are sequentially renumbered starting with 1 as indicated below:
Bentley AutoPIPE
Bentley Technical Support KnowledgeBase
Bentley LEARN Server
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article tothe "Comments" area below. THANK YOU!