Problem:

How does a QA&R user install AutoPIPE?

Answer:

Note: If you are part of the QA&R program, any installation from a downloaded file for AutoPIPE or ATS is strictly forbidden and does not constitute a valid installation or verification. All QA&R user must install the applications from the CDs received from Bentley systems QA&R manager (ref. QAP -Rev.11 section 7.2 SOFTWARE DISTRIBUTION).

See the following steps required for a valid QA&R installation of AutoPIPE:

Step #1: Get the official QA&R CD that was mailed from Bentley.

Step #2: Install the CD into the computer where AutoPIPE is to be installed.

Step #3: Use ‘My Computer’ to browse to the CD and double click on the file, Quickstart_AutoPIPE.pdf. 

Step #4: See Chapter 2: Installation Guide, go to the page for "Install from CD"

Step #5: Perform the instructions as written in order to install the application from the CD. 

Step #6: Scroll down a few pages in the document to see a listing of screen shots that will be presented, ending with pressing the Finish button, shown below:

Step #7: Before starting AutoPIPE it must be licensed, see the document section on "License Setup Guide". there are 2 options. Perform the steps required for the option being used.

Note:

a. Select here for information to find Bentley On-site Admin.

b. Select here for information to find SELECTserver name and Site ID

See Also

How do I download, install, and license AutoPIPE?

Bentley AutoPIPE