You are currently reviewing an older revision of this page.
The following is displayed when using Rotating Equipment module in AutoPIPE:
---------------------------Error--------------------------- E102-155: This point must be an anchor/reference point---------------------------OK ---------------------------
how to avoid it?
Open the Rotating Equipment dialog, all the node point fields must be an anchor or reference point in the model:
Cannot Specify a normal run, bend, tee, flange, etc.. type node point.
None, again the node point names specified in these fields must be an anchor or reference not point.
Error Messages
Bentley AutoPIPE
Bentley Technical Support KnowledgeBase
Bentley LEARN Server
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article tothe "Comments" area below. THANK YOU!