You are currently reviewing an older revision of this page.
When importing a PCF file into AutoPIPE, noticed that soem of the base supported elbows were missing:
example:
should have been an elbow with a support. Instead both support and elbow were found missing form the translated file.
Why and how to avoid / fix?
This was due to improper “Base Elbow Support” attached to this bend.
Example:
The issue was that the coordinates on Port 3000 & 3020 was not same which was against PCf standard.
This problem was with the exported PCF file from OpenPLANT and fixed in OpenPlant 8.11.11 (SS6) and higher.
Update to newer version of software before exporting new PCF file.
PCF Translator FAQ & troubleshooting
Bentley AutoPIPE