You are currently reviewing an older revision of this page.
The following is displayed when setting the Nozzle Axis:
---------------------------APNozzle---------------------------Same shell and nozzle axis selected---------------------------OK ---------------------------
Why and how to avoid?
As the message states, the Shell and Nozzle
The problem is that the Normal axis and Nozzle axis have the same setting, Note the axis designations in the image tile, see +Y is labeled 2 times.
Change one of the axis direction so that all 3 axis directions are different as shown below:
Warnings, Errors, Crashed, Confirm Messages
Bentley AutoPIPE