You are currently reviewing an older revision of this page.
The following is displayed when setting the Nozzle Axis:
---------------------------APNozzle---------------------------Same shell and nozzle axis selected---------------------------OK ---------------------------
Why and how to avoid?
Given the AutoPIPE Nozzle settings below:
The problem is that the Normal axis = +Y and Nozzle axis = +Y, this is confirmed by referring image tile, see +Y is labeled on 2 axis directions.
Change one of the axis direction so that all 3 axis directions are different as shown below:
Warnings, Errors, Crashed, Confirm Messages
Bentley AutoPIPE