You are currently reviewing an older revision of this page.
01. What is the formula used for hydro-test pressure calculations per CODAP Div. 1 used for Shell and Tube Heat Exchangers in AutoPIPE Vessel?
02. How to check for bolt load calculations for longitudinal saddle load generated during bundle pullout?
03. Does the calculation of a body flange according to ASME VIII, div 1, consider a rigidity criterion in an AutoPIPE Vessel model?
04. How to calculate the tensile stress in bolts of an AutoPIPE Vessel model?
05. Allowable stresses input by user for test conditions in AutoPIPE Vessel
06. The Calculation Strength command or button is grayed out, How to resolve this in AutoPIPE Vessel?
07. What is the theory being C-factors derivation as per UG-34 in AutoPIPE Vessel?
08. When I select a component and click on "Show Selected Report Calculation Details", nothing seems to happen. What is the solution?
09. Why does the AutoPIPE Vessel calculate different wall thickness for a vertical vessel where one chamber is made with 2 sections of the same material?
10. Rounding Error - value of pi
11. Results are different when using different versions of AutoPIPE Vessel
12. Longitudinal loads on saddles
13. How are the RAHL values calculated? When do the sliding saddles start to move in AutoPIPE Vessel?
14. Obtaining foundation load in AutoPIPE Vessel
15. How do I analyze a rectangular vessel attachment or wear plate?
16. How to perform calculations for test case in AutoPIPE Vessel?
17. How AutoPIPE Vessel Calculate Corrosion Allowances as UG- 45 or ASME VIII div.1?
18. The "Period" is calculated by what method in AutoPIPE Vessel?
19. Why saddle support reactions are 0.00 in an AutoPIPE Vessel output report?
20. How do you analyze a head with a skirt smaller than the diameter of the head?
21. How AutoPipe vessel takes care of Saddle if its placed on Transition element like Cone?
22. Consequence of the input of the elevation in the dialog of the bracket or ring in AutoPIPE Vessel?
23. How do you enter f1 and f2 for cone calculations in ASME VIII mandatory appendix 1-5?
24. I am designing EN code tubesheet, where do the terms l1, l1' and gamma (γ) come from?
Bentley AutoPIPE