| Applies To | |||
| Product: | AutoPIPE | ||
| Severity: | High | ||
| First Affected Version: | 11.04 | ||
| Fixed and Released in Version: | 12.08.00.063 |
Title
Max Ratio for flange with ANSI check is displayed incorrectly in the Flange Summary report
Reported Description
For any ANSI enabled flange, Max. ratio is the maximum pressure ratio selected from multiple load combinations under 'ANSI Flange Check'. This ratio is reported in the Flange Summary report section generated using Output Reports (Result > Quick Reports > Output Report). The program was reporting this maximum ratio incorrectly e.g.
(1) When there are two flanges on the same point and only the second flange is ANSI enabled, the program reported a 'Zero' max ratio for the ANSI flange. In some cases, there is an incorrect non-zero value reported.
(2) When there are two flanges on the same point and both the flanges are ANSI enabled, the program reported the correct max ratio value for the first flange and incorrect max ratio for the 2nd flange as a duplicate of 1st flange.
Avoidance
The highest value of pressure ratio can be read from the ANSI Flange Check report for ANSI-enabled flanges.
Solution:
The program should report the correct value of Max Ratio for flanges with ANSI check in the Flange Summary report
Also See:
Critical and High issues released in AutoPIPE CONNECT v.12.08