You are currently reviewing an older revision of this page.
Animate load cases
AutoPIPE Menu - Load>
Load Case Descriptions
Static Analysis Sets...
Dynamic Analysis
Load Factors
Hydrotest
Static Earthquake...
Wind
Snow
Thermal Bowing
Seismic Thermal Load
Response / Force Spectrum
C411 Spectrum
Envelope Spectrum
Harmonic
Time History Profile
Convert to Force Spectrum
Convert to Response Spectrum
Buoyancy
Wave
Fluid Transient
Steam Relief
Load cases not listed above:
Gravity
Pressure
Temperature
Sam (Seismic Anchor Movement)
Fatigue
Results From Loads and Load Sets Not Answered By Piping Code Calculations
Code / Non-code Combination / Allowable
Non-linear Load Sequencing
How to determine fatigue from pressure cycles?
Answer: Apologize for the inconvenience, this feature is not currently in AutoPIPE. This enhancement has been logged under (CAE-CR-3268). However, only AutoPIPE Vessel has ability to determine fatigue from pressure cycling at this time.
Soil Properties FAQ
Q1. How to delete load cases from the model input grids?
A load case cannot be deleted from the Input grids by using Static Analysis Set dialog.
Load Cases are added to the model based on settings within specific dialog screens. The same load cases are removed from the model by making changes on the same dialog screens.
Examples:
1. A Wind load case W3 is deleted from the model using the Wind dialog screen, selecting the Load case W3 and pressing the Delete button.
Load case W3 is added and removed from a Static Analysis set by enabling / disabling the check box next to the load case on the Static analysis Load set dialog screen, shown below:
Table Of Contents - AutoPIPE Wiki page
Bentley AutoPIPE