You are currently reviewing an older revision of this page.
The following is displayed in model consistency check report:
W726-7: Pipe diameter change without a reducer at point XXX
This warning message is displayed whenever there is a difference in pipe properties OD or wall thickness between two sucessive points in a model without a reducer.
Insert a reducer between the 2 different pipe properties.
Accept the warning as OK, and ignore the warning as the joint is correctly modeled. Insert a user Joint type / SIF added as needed.
Bentley AutoPIPE
Bentley Technical Support KnowledgeBase
Bentley LEARN Server
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article tothe "Comments" area below. THANK YOU!