You are currently reviewing an older revision of this page.
The Load> Wind command enables the user to define static wind load cases (W1 - W10) by generating wind pressure:
Vs. Profile piping height profiles
Per ASCE 7 1998, 2002, or 2010 code
Per Uniform Building Code (UBC) requirements.
After specifying a new wind load case, select the first cell in the left column to highlight the row and press the Modify button to see more settings for the specified Wind Load Type as indicated below:
The wind force is applied as uniform loads in the local coordinate system of the straight pipe or bend element. The equivalent wind force is assumed to act through the centroid of the element.
Wind loads will only be applied to piping if both conditions are meet:
1. segments that have "Applied Wind" checked on. I
2. Wind load case must be enabled inside of an analysis set:
Segment Tab on the input grids:
Load> Static Analysis Sets> modify analysis set:
AutoPIPE 11.02.00.08 and higher: Wind loads defined in the model can be applied to that structural member.
AutoPIPE 11.01.xx and lower: Beam members are not subjected to wind loads, enhancement has been logged, (135281).
In order to exclude piping inside a building from wind loads, the piping inside should be entered as a separate segment(s) from the piping outside the building.
With the model Input grid opened, select the Segment tab, see column labeled "Apply Wind". Segments with Applied Wind enabled are considered outside, while segments with Apply disabled are considered inside.
When specifying wind load profile elevation values, remember to check that ground is correctly defined on the main Wind dialog screen. This applies also to wind loadings per ASCE-7 and UBC.
Opening older AutoPIPE models may display a warning message "negative elevations found" may indicate an incorrect wind loading across this model.
If the Wind Ground elevation value was found to be greater than all the vertical pipe coordinates in a model, than the entire model would be considered to be underground and thus no Wind load will be applied. Confirm Wind load ground elevation relative to the piping model.
The following only affects AutoPIPE V8i 09.06.00.15 and will be fixed in the next new version 09.06.01.xx and higher:
The Ground Elevation for Wind is always entered in Feet, regardless of the model units file specified on Tools> Model Options> General dialog . This can be confirmed with the Loads Summary Data Listing report using any metric units file (CAE-TR-11097).
Loads and Load Sets - AutoPIPE