You are currently reviewing an older revision of this page.
Attention. Please see the following AutoPIPE help section. Help > Contents> Contents Tab> Modeling Approaches> Modeling Approaches>This help has been provided in order to give users ideas for modeling typical piping arrangements. The steps shown in each example should not be taken as the only method available to create models. In addition, the intent of the examples is to present ways to create adequate models of specific piping components for analytical purposes. Anchors Bends Cuts Flexible Joints Frames Hangers Nozzles Pipes Reducers Rotating Equipment Supports Tees Valves Vessels
0. Video Tutorial on modeling a Tee
In AutoPIPE select Help> Tutorial> First Tutorial> Creating a New Model> Insert a Tee
1. Weight of a typical pipe fittings (i.e. Tee, elbow, reducer, etc..)
2. Branch piping using 3 different methods
3. Connect 2nd segment Piping to Header Pipe
4. Branch piping on an elbow
5. Flanged cross pipe fitting
6. USER SIF values
7. Y-pipe fitting
8. Correct a incorrectly modeled Tee
9. Connect 2 parallel pipes with branch piping
10. Reducing Tee
11. Cannot model branch piping
12. Model a Saddle supported Tee branch connection
13. Tee arrows do not appear
14. Test if a branch pipe is actually connected to a header pipe
Model Different Types of PIPING Components
Bentley AutoPIPE