Enhancements and defects for Edit commands:

Selecting
Undo
Redo
Cut
Copy
Paste
Delete
Move/Stretch
Rotate
Scale
Segment
Renumber
Goto Point
Beam..
Goto Beam
Next Beam
Prev Beam

Note: if an enhancement or defect has not been added to the program, log an Service request for that enhancement. The more requests logged per an enhancement, the quicker the CAE development team will add that feature to the program.

The following enhancements and defects have already been requested:

Defect 889911:

Program crash on copy if model has a segment that starts at valve end

Updated Version: TBD

Work Around:

For new models: Don't start new segment at end of valve.

For existing models:

Join the two segments (Home > Segment > Join)

Insert a piping point after valve, which is in same segment as of the valve

Defect 782853:

Copy/Paste: new pipe id is created on paste even same pipe id exist in model

Updated Version: TBD

(No number) AutoPIPE v 12.04 reported issue:

Node point selection jump to random location

Work Around:

- Download and install AutoPIPE 23.00.01.367 or higher.

- If unable to upgrade, accept the issue and continue to try and select the correct node point using:

a. Mouse and Left mouse button to select node point.

b. Goto point command

c. Make modifications directly in the input grids as needed.

================================================================

Defect 759465:

Rotate dialog limits the angle to be 5 characters only

Updated Version: 12.07

Enhancement 723766:

Dynamic analysis dialog: Pressing OK shall remove the unavailable support groups from response spectrum load sets

Steps to Repeat:

1.Open MSRS_Example model
2.Delete imposed displacement at point 17
3.Running "Consistency Check" reports "W2143-29:Response spectrum case R1 has support group 3 that is no longer defined in model."
4.Running "Analyze All" command gives message "E801-24: Number of MSRS groups is inconsistent with SAM case"
5.Open dynamic analysis dialog and go to Response Spectrum tab
6.Click on define button in Spectra column
7.Notice that the support group 3 is not available.
8.Press OK, and again press OK to close dynamic analysis dialog.
9.Run consistency check and analyze all commands and notice that the message is still given.

Workaround:

- Open dynamic analysis dialog
- Go to Response Spectrum tab.
- Click on define for load sets reported in consistency check
- Change a single scale factor or just write same value again.
- Click apply button & then click OK.
- Click OK to close dynamic analysis dialog.
- Run Consistency check and Analyze All commands and notice that no message is given this time.

15. "Edit" Commands Enhancements & Defects for AutoPIPE

Enhancements and defects for Edit commands:

Defect 889911:

Program crash on copy if model has a segment that starts at valve end

Defect 782853:

Copy/Paste: new pipe id is created on paste even same pipe id exist in model

(No number) AutoPIPE v 12.04 reported issue:

Node point selection jump to random location

Defect 759465:

Rotate dialog limits the angle to be 5 characters only

Enhancement 723766:

Dynamic analysis dialog: Pressing OK shall remove the unavailable support groups from response spectrum load sets

Enhancement 197854:

Copy / Paste piping with buoyancy loads

Enhancement 121179:

Add feature to use mouse in specifying rotate point.

Enhancement 101317: Tracker#: 1231

Rotate geometry, supports, local and global static loads

See Also