You are currently reviewing an older revision of this page.
When analyzing a model the following occurs:
--------------------------- Confirm --------------------------- The load case did not converge. Do you wish to continue iterating? --------------------------- Yes No Cancel ---------------------------
What should I do?
Selecting YES: The program will re-run the analysis for more iterations in hopes of converging below the non-linear tolerances specified.
The default number of iterations is 30, If it was determine that 31-99 iterations enabled the analysis to converge, make this a permanent change by changing the Nonlinear analysis> Maximum iterations settings, as shown below
Then each time an analysis is performed it will use the updated number of iteration thus reducing likely hood that the message above will be displayed.
Selecting No: Stops the analysis procedures and presents the following:
--------------------------- Confirm --------------------------- Do you want to see .LOG file for magnitude of unbalance error? --------------------------- Yes No Cancel ---------------------------
Selecting Yes: AutoPIPE Viewer is automatically displayed with the *.LOG for review.
Selecting No: The dialog is closed and user is able to enter the next AutoPIPE command.
Selecting Cancel: The dialog is closed and user is able to enter the next AutoPIPE command.
Confirm Messages displayed in AutoPIPE
Bentley AutoPIPE
Bentley Technical Support KnowledgeBase
Bentley LEARN Server
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article to the "Comments" area below. THANK YOU!