You are currently reviewing an older revision of this page.
Word Wrap
The following is displayed in AutoPIPE when trying to perform an analysis:
---------------------------Error--------------------------- E801-3: No static load cases specified---------------------------OK ---------------------------
The problem is located in Load> Static Analysis sets> there is no load case defined
Be sure that at least one load case has been selected for analysis as shown below:
Notes:
1. in order to select a load case press the Modify button
2. When adding a Hydrotest, be sure to open the Hydrotest Load Properties dialog make adjustments and press OK button before analyzing.
In addition, check the Tools> Model Options> General> Edition year is not blank:
If blank, select a valid Edition year from the drop down listing.
See Also
Error Messages
Bentley AutoPIPE
Update Cancel