You are currently reviewing an older revision of this page.
The following is displayed in AutoPIPE when trying to perform an analysis:
---------------------------Error--------------------------- E801-3: No static load cases specified---------------------------OK ---------------------------
The problem is located in Load> Static Analysis sets> there is no load case defined
Be sure that at least one load case has been selected for analysis as shown below:
In addition, check the Tools> Model Options> General> Edition year is not blank:
If blank, select a valid Edition year from the drop down listing.
Error Messages
Bentley AutoPIPE
Bentley Technical Support KnowledgeBase
Bentley LEARN Server
Bentley's Technical Support Group requests that you please submit any comments you have on this Wiki article tothe "Comments" area below. THANK YOU!