How to add Nozzle size on Isometric?

Question

When we extract the isometric which is connected to Equipment Nozzle, normally it shows the Nozzle Tag, Nozzle Rating and Nozzle facing in continuation. 
 But I want to add Nozzle size as well in continuation. Can you please help me to achieve that? 
 We are using AutoPLANT SS4. 
 Thanks and Regards 
 Sandip Badgujar

Abhijit Bute · Accepted Answer

Hello Sandip, 
 
Could you please try following steps: 
1. Open C:\Program Files (x86)\Bentley\Plant V8i\Modules\Base\xchg\pcf\eqpnozz.ebs. 
2. Go to Line 85 and insert the code below under the code for `// Nozzle Facing: 
 
`// Main_size 
status = at_Component_getstring (tempStr, compID, "NPS_MAIN") If ((status = AT_SUCCESS) And (Len(tempStr) > 0)) Then 
refText = refText + "$MAIN_SIZE " + RTrim$ (tempStr) End If

3. Save and close the file. 
 
Hope this helps. 
 
Regards, 
Abhijit Bute

Artiom J · Answer

Hi Sandip, 
 In order to get nominal nozzle size in continuation reference message the following ebs file should be edited: 
 C:\Program Files (x86)\Bentley\Plant V8i\Modules\Base\xchg\pcf\eqpnozz.ebs 
 As well same file could be stored on project level PROJECT_ROOT\Config\Modules\Base\xchg\pcf\eqpnozz.ebs 
 Add below code to eqpnozz.ebs starting from line 92: 
 '// Nozzle Size status = at_Component_getPortND(tempStr, compID, "NP1") If ((status = AT_SUCCESS) And (Len(tempStr) > 0)) Then refText = refText + "$SIZE " + RTrim$ (tempStr) End If 
 
 As a result you should get following iso output: 
 
 The message is being split due to amount of reference information. 
 I hope this will be useful. Please let me know if you will have further questions. Kind Regards, Artiom

Rahul Kumar · Answer

Hello Sandip, 
 Are you trying this with OpenPlant Isometrics Manager or an ISOGEN? we have a similar content available in context with OpenPlant Isometrics Manager. Please have a look below: 
 http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki/17255.add-nozzle-rating-and-facing-information-in-continuation-nozzle-expression 
 Regards, Rahul Kumar