Pass an PFD from AXSYS to OPPID

hello, I pass a P&ID from AXSYS to OPPID and the conversion works without problem, now I want to pass a PFD from AXSYS to  OPPID to  draw a P&ID (in OPPID), when I want to pass the file  to OPPID I have the following error :




exist any procedure to pass the PFD to OPPID?

Comments:

I save the file in the format "Autoplant DWG",  this format was the only one that throw an error.

I tried with the other formats and nothings happened with the conversion.

regards!

Parents
  • Juan,

    It looks like this PFD file is missing a referenced block (at_asi_ldwg). However, I do believe that block is an AutoPLANT P&ID block. This message might be incorrect. Can you verify that your other AXYS PID drawings had that at_asi_ldwg block in it before conversion? What happens if you continue past this message? Can you run Conformance Tool on the components in the PFD?

    Thank you,

    Brandon Moberg

Reply
  • Juan,

    It looks like this PFD file is missing a referenced block (at_asi_ldwg). However, I do believe that block is an AutoPLANT P&ID block. This message might be incorrect. Can you verify that your other AXYS PID drawings had that at_asi_ldwg block in it before conversion? What happens if you continue past this message? Can you run Conformance Tool on the components in the PFD?

    Thank you,

    Brandon Moberg

Children