Hi All,
I'm sorry if this has already been asked, but I was unable to find anything apart from AutoPLANT answers on Flexible hoses.
In OpenPlant Modeler I have been unsuccessful in placing a flexible hose where the hose has read the Piping Spec. Each time I attempt to place a hose the following is shown in the Message Center - "No component found with initial selection from specs"
Looking at the schema, I can't see any difference between a Pipe and Flexible hose when it comes to the spec.
Can you supply an example spec with a flexible hose that works with OPM and OPIM.
Thanks
Ray