Hello,
The piping model I was updating unexpectedly received errors when launching AutoPlant. I was using AutoPlant without any issues one minute, closed down the model to rerun the Navisworks file and re-entered to continue working whereby at this point I received the following error:
My previous session of AutoPlant successfully saved and closed down without any known issues. No error warnings etc.
If I say no to the above dialogue box then I receive the following messages:
Finally, if I try to continue working in AutoPlant and try to make and changes, add anything new, then this eventually causes the model file to crash upon receiving this final warning message:
I so far have attempted to use the ‘back-up’ model file from a period prior to receiving these problems yet this for some reason still prompts the same issues. As it stands I am unable to make any design progress with this model file in particular. FYI, a colleague of mine is working on a different model file and has not received any errors in his area, yet does receive the same errors that I experience if he attempts to open up my file. It seems the errors are confined to the model file rather than user/PC.
Any assistance which could help resolve these errors would be greatly appreciated.
Regards,
Phil Wheatley.