In OPIM build 08.11.09.572, in our model we have a vertical pipe with a very slight offset. It's 3 inches in the horizontal for 15 feet in the vertical. It comes out to less than 1 degree. The isometric shows the proper location for the pipe at the low point and farther along the piping at the high point, but does not indicate an offset or supply a dimension for the difference in location between the low and high point for the piping. This would cause installer to weld the piping incorrectly, thinking it was vertical.
I can't find a tolerance setting for dimensions to have it show an offset. Where can I find one or what can I change to make the offset dimensioned?
Hello Richard,
Can you supply an image to it, to make it more clear to us?
-Regards | Rahul Kumar
Regards,
Rahul Kumar
Product Engineer – Global Technical Support | Community Moderator
Here is an image. I've simplified it to make it easier to read but you can see that there is a 3 inch difference in the North location yet the drawing does not show an offset from the top of the vertical run to the bottom.
Thanks Richard,
I would suggest you to create SR for this and upload Intermediate file, i models & DGN file for further investigation and enable us to discuss it further with product Management.