Unable to add drawing name in Isosheet Manager

I'm making isometrics in OpenPlant Isometrics Manager and I have now reserved some document numbers from our archive and I'm looking for best practice to adapt those drawing numbers in the isometrics. There is in Drawing Name field at properties but that is gray and I cannot edit that. How I can edit that field? Or is there some other suitable way to do this?

 

Parents
  • Hello Tuomas, 

    Are you maintaining xls file for document number control. There are ways to get it included inside property tab. However one simpler way has been described below to allow user to edit the field and enter the data.

    These Attributes you may refer inside ISO_SHEET class. Below quick step to check

    1. Open OpenPlant_3D.01.07.ecschema from class editor. 
    2. Supplement it with OpenPlant_3D_Supplemental_Modeling as well as OpenPlant_3D_Supplemental_Modeling Views schema.
    3. Search for ISO_SHEET class.
    4. From Property tab, refer ISO_DRAWING. 
    5. Inside Property Display Status custom attribute, make it editable. 



    6. Close schema & verify results. 



    You may refer similar wiki article for your working. 

    Applies To Product(s): OpenPlant Modeler Version(s): 08.11.09.XXX & 08.11.11.XXX Environment: Windows 7 (64 bit), 10 (64 bit) Area: Settings/Attributes Subarea:…
    Last edited in OpenPlant | AutoPLANT > OpenPlant | AutoPLANT Wiki

    HTH 

    Regards,

    Rahul Kumar

    Product Engineer – Global Technical Support | Community Moderator

    Answer Verified By: Tuomas Takkinen 

Reply
  • Hello Tuomas, 

    Are you maintaining xls file for document number control. There are ways to get it included inside property tab. However one simpler way has been described below to allow user to edit the field and enter the data.

    These Attributes you may refer inside ISO_SHEET class. Below quick step to check

    1. Open OpenPlant_3D.01.07.ecschema from class editor. 
    2. Supplement it with OpenPlant_3D_Supplemental_Modeling as well as OpenPlant_3D_Supplemental_Modeling Views schema.
    3. Search for ISO_SHEET class.
    4. From Property tab, refer ISO_DRAWING. 
    5. Inside Property Display Status custom attribute, make it editable. 



    6. Close schema & verify results. 



    You may refer similar wiki article for your working. 

    Applies To Product(s): OpenPlant Modeler Version(s): 08.11.09.XXX & 08.11.11.XXX Environment: Windows 7 (64 bit), 10 (64 bit) Area: Settings/Attributes Subarea:…
    Last edited in OpenPlant | AutoPLANT > OpenPlant | AutoPLANT Wiki

    HTH 

    Regards,

    Rahul Kumar

    Product Engineer – Global Technical Support | Community Moderator

    Answer Verified By: Tuomas Takkinen 

Children