I'm making isometrics in OpenPlant Isometrics Manager and I have now reserved some document numbers from our archive and I'm looking for best practice to adapt those drawing numbers in the isometrics. There is in Drawing Name field at properties but that is gray and I cannot edit that. How I can edit that field? Or is there some other suitable way to do this?
Hello Tuomas,
Are you maintaining xls file for document number control. There are ways to get it included inside property tab. However one simpler way has been described below to allow user to edit the field and enter the data.
These Attributes you may refer inside ISO_SHEET class. Below quick step to check
You may refer similar wiki article for your working.
How to Make Properties Values Editable in OpenPlant Modeler Applies To Product(s): OpenPlant Modeler Version(s): 08.11.09.XXX & 08.11.11.XXX Environment: Windows 7 (64 bit), 10 (64 bit) Area: Settings/Attributes Subarea:… Last edited over 6 years ago in OpenPlant | AutoPLANT > OpenPlant | AutoPLANT Wiki
HTH
Regards,
Rahul Kumar
Product Engineer – Global Technical Support | Community Moderator
Answer Verified By: Tuomas Takkinen
I noticed one more item, if I run the Autogenerate Iso-sheet it will empty the Drawing Name Field and I have always put the drawing number again manually. Is there any way to save the number that Autogenerate Iso-sheet will not empty that field?
No Tuomas,
Currently user need to re-enter the data and finalize the document number.
HTH,
For the information, found an workaround for this in our case. Currently in our system there will be only one drawing number per each pipeline so I added a new property under pipe called DWG_NR. This can be shown in the drawings and Autogenerate will not empty this.