In some cases we get 'Physically Close' and Connectivity checker will not fix Joint.
How to set the allowable Gap?
How to ensure this will also work on Iso?
Hi Peter,
If this is happening because of replacing gasket then you need to check the thickness and get it from spec grid option available in connectivity checker dialog box.
For tolerances to be adjusted there are variables present in project configuration file (*.pcf). Refer connectivity tolerance section in below wiki
OpenPlant Configuration Variables Applies To Product(s): OpenPlant Modeler Version(s): 08.11.09.XXX (SS5) | 08.11.11.XX (SS6) Environment: Windows 7/8.1/10 (64 bit) Area: Settings\Attributes Subarea… Last edited over 7 years ago in OpenPlant | AutoPLANT > OpenPlant | AutoPLANT Wiki
HTH,
Regards,
Rahul Kumar
Product Engineer – Global Technical Support | Community Moderator
Did a test with moving 0.5 (Set to 2)
Yepp, this works for Connectivity Checker, but gives error when producing Iso..
The question is
Is there a way to set Misalignment_Allowance for IsoMetricManager