OpenPlant Modeler > PlanSight is not active

OpenPlant Modeler > PlanSight is not active

Parents
  • Hi Jose,

    I can see couple of issues here.

    To get rid from this SPC error, you can create layout of OpenPlant Modeler setup and install SPC component via *.msi file.

    Since you are moving from lower to higher version, there are schema changes that points the locations for SPC structural schema. If that is not configured properly, it might throw the same error message.

    You also, need to clean the local briefcase, if unable to solve the issue by above methods.

    Regards
    Deepak Singh

Reply
  • Hi Jose,

    I can see couple of issues here.

    To get rid from this SPC error, you can create layout of OpenPlant Modeler setup and install SPC component via *.msi file.

    Since you are moving from lower to higher version, there are schema changes that points the locations for SPC structural schema. If that is not configured properly, it might throw the same error message.

    You also, need to clean the local briefcase, if unable to solve the issue by above methods.

    Regards
    Deepak Singh

Children