• Bolt-Length Calculation [OPM – 10.07.00.32]

    Hello everybody, For your convenience, a “too long did not read”: I think the algorythm to choose a correct bolt length is not working correctly together with the Increment value “BOLT_INC”. It produces wrong values and does not represent the way…
  • RE: Replaced Bolts using Fix Disconnects

    Hi, 1. You can check first by creating iso sheet again and verifying it inside iso sheet manager if sheets created successfully. 2. In intermediate file, check if fasteners available or not. Are there only Bolts which are not appearing or gaskets…
  • Gaskets and Bolts on end of line valve appear on continuation isometric

    Good Day, We have 2 lines with the following components: Line 1 consists in a Pipe, Flange, Gaskets/bolts, Valve, Gaskets/bolts Line 2 consists in Flange, Pipe The connection between line 1 and line 2 are line 1 Gaskets/bolts and line 2 Flange…
  • AutoPLANT Modeler, Lined Pipe, Bolt Calculation

    Hi, AutoPLANT Modeler SS7r1 (.239) Lined Pipe Module Bolt calculation is not done when inserting two fittings. Works fine when something is in between the flanges. Calculated Bolt Length is set to Yes SH
  • RE: What's the bolt/gasket selection rule at spec break

    Hi Changsong, It queries bolts and gaskets from the spec of mating flange. In case of nozzle, it will query the bolts and gaskets from the spec of flange being placed. Is there any different behavior on your side or any error message? Regards, Ha…
  • RE: Is there a easy way to select all bolts which used on different end preparation in OPM?

    Thanks to confirm Changsong, There is a wiki article to refer similar content. http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki/29496.how-to-update-bolts-and-gaskets-in-openplant-modeler I am…
  • RE: Bolt Length cannot be calculated

    Hi Changsong, We have several wiki articles on Bolt Length calculation which will give you an idea on how is bolt length calculated. One of them is given below: http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki…
  • How to prepare Catalogs of hexagon bolts, hexagon nuts and washers

    Hi all. I've got a problem. I've prepared weld neck flanges and blind flanges catalogs. Now I should prepare catalogs of bolts, nuts and washers suitable to my flanges catalogs. I found only these components about "bolts", but nothing more (nuts,…