You are currently reviewing an older revision of this page.
During the placement of bolts in a component, the description field value does not update the bolt length (BOLT_LEN) calculated value and takes the default as per the value defined in Spec and hence taken up the same by user.
Bolt length calculation is being done prior to the placement of bolts and hence it shows the selected bolt length available in spec grid. In description field the BOLT_LEN property value does not takes the updated value. See specific generator entry for bolts where it has been described:
It is expected to show an updated value for bolts after placement. To have the updated bolt length in description below customization required:
Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!