You are currently reviewing an older revision of this page.
To show Corner type elbows in OpenPlant Isometrics drawing.
In OpenPlant Isometrics Manager, currently elbows show as round in isometrics drawing. Sometimes it is expected to have an elbow with corner type having edge. This can be done by modifying the cell templates and defining variable in schemas. It can be experienced using both OpenPlant modeler & AutoPLANT Modeler with OpenPlant Isometrics Manager. Below steps illustrates using AutoPLANT Modeler with OpenPlant Isometrics Manager.
For Weld Symbols & other similar changes refer below link:
Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!