Issue with placement of Isometric Break Point on Mating Flange Assembly in OpenPlant Modeler


Applies To
Product(s):OpenPlant Modeler
Version(s):08.11.09.404 & above
Environment:Windows 7/8.1/10 (64 bit)
Area:Component
Subarea:Graphics
Original Author:Rahul Kumar, Bentley Product Advantage Group

Overview

Placement of Note type, Isometric Break point on mating flange assembly is the requirement from user. As shown in image below:

            

Problem Description

Sometimes it often shows a message ‘Select valid Piping Component’ and not allow user to place notes correctly. See image below. Below steps explains on placing the note type correctly.

           

Steps to Resolve

  1. Place a pipe and mating flange assembly.
  2. Click on Snap Point. 



  3. When Iso Break point appears, drag the pointer to desired location, say midpoint flange & gasket.



  4. After clicking it automatically picks up the correct location.



  5. Also see isometric image:

Comments or Corrections?

Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!