Applies To
	Product(s):	AutoPLANT Isogen
	Version(s):	08.11.XX.XXX
	Environment:	Windows 7 64/32 bit
	Area:	Configuration
	Subarea:
	Original Author:	Abhijit Bute, Bentley Technical Support Group

Error or Warning Message

Explanation

One of the project gives this error when generate isometric through Isogen.

How to solve

Refer following steps to resolve this issue.

1. Open the file C:\Program Files (x86)\Bentley\Plant V8i\Modules\Base\PCF.INI.

2. Add PWF = SW under the section [MAP_ENDCOND4SKEY] as shown below:

<C R>[MAP_ENDCOND4SKEY]
SCF = SC
SCM = SC
SWF = SW
SWM = SW
SOF = SW
BW = BW
BV = BW
FL = FL
FLL = FL
PWF = SW

3. Save and close the file PCF.INI.
4. Run Isogen.

Comments or Corrections?

Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!