You are currently reviewing an older revision of this page.
Error or Warning Message
One of the project gives this error when generate isometric through Isogen.
Refer following steps to resolve this issue.1. Open the file C:\Program Files (x86)\Bentley\Plant V8i\Modules\Base\PCF.INI.2. Add PWF = SW under the section [MAP_ENDCOND4SKEY] as shown below: <C R>[MAP_ENDCOND4SKEY] SCF = SC SCM = SC SWF = SW SWM = SW SOF = SW BW = BW BV = BW FL = FL FLL = FLPWF = SW 3. Save and close the file PCF.INI. 4. Run Isogen.