You are currently reviewing an older revision of this page.
In OpenPlant Modeler, after Section clip placement and projection generation User is willing to have all centerlines visible.
During Modeling in OpenPlant Modeler after Section clip placement, pipelines axes are shown only in the case where the sectional surface intersects the tube. Below are the steps of how to turn on Centerline visibility.
See Similar link for related problem on placement issue:
http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki/22659.how-to-show-centerline-on-hvac-ducts
Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!