When trying to save the OpenPlant Model in DWG format below error message appears.
This error message appears because MS_DWGSEED variable points to Opimseed.dwg file rather than seed.dwg file. Please see below:
This variable is defined in the isoproj.cfg file as shown below. Currently, opimseed.dwg file is used by OPIM to generate isometrics in DWG format and OpenPlant Modeler doesn’t use this file.
NOTE: As mentioned above, opimseed.dwg file is required when you need an isometric output in DWG format. Therefore, if you need to use this variable both ways i.e. 3D Model and Isometrics output as DWG format, then you need to follow the steps given below.
Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!