You are currently reviewing an older revision of this page.
To Assign FieldFit Weld Allowances for BOM CutList in OpenPlant Isometrics Manager.
In OpenPlant Isometrics Manager, Field Fit weld allowances has been needed in BOM cut list report to allow extra length of pipe to order which can be further trimmed for end preparation at site. However assigning extra length will not show up in DWG dimension, but it will report in BOM for ordering the extra length. This could be realized using both AutoPLANT Modeler and OpenPlant Modeler user with OpenPlant Isometrics Manager. Check below steps described for both ways.
A. Using AutoPLANT Modeler & OpenPlant Isometrics Manager
B. Using OpenPlant Modeler & OpenPlant Isometrics Manager
http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki/19833.how-to-add-weld-tag-as-fwffw-on-isometrics-weld-in-openplant-isometrics-manager
Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this Comments or Corrections?" section. THANK YOU!