You are currently reviewing an older revision of this page.
There are cases where OpenPlant model has insulation over piping components for various needs. OpenPlant Orthographics Manager has certain options which enable to control representation of insulation in an orthographic drawing.
Steps to Accomplish
Case I - Show Insulation in the output
Below steps should be used to show Insulation
Case II- Insulation not required to be shown in the output
Currently, in Standard mode there is no option available to switch off insulation for elbows and other piping components so we will use MicroStation Dynamic View.
Comments or Corrections?
Bentley's Technical Support Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU!