You are currently reviewing an older revision of this page.
Applies To
Product(s):
OpenPlant Modeler
Version(s):
08.11.11.87 (SS6)
Environment:
Windows 7/8.1/10 (64 bit)
Area:
Component
Subarea:
Data
Original Author:
Faisal Khan, Bentley Product Advantage Group
To Place Fasteners and Flanges of Same Ratings in OpenPlant Modeler
User was placing Y-Strainer of PN16 rating. Now after Y-Strainer placement, user was asked for Bolts and Gasket placement. User placed Bolts and gaskets twice (for both ends) of PN16 ratings. Flange selection table was not popping up and it automatically placed flanges but of different rating i.e. PN10. User wants to have a selection dialog for Flanges as well as same ratings of all components i.e. Y-Strainer, Bolts, Gaskets and Flanges.
If above problem still persist, then please create a Service Request and contact the Bentley Product Advantage group. Please include a list of all relevant details to get in depth analysis for a solution or workaround.
Bentley's Product Advantage Group requests that you please confine any comments you have on this Wiki entry to this "Comments or Corrections?" section. THANK YOU